IJE_Vol 02 N 01
Permanent URI for this collectionhttps://archives.univ-eloued.dz/handle/123456789/20302
Browse
Browsing IJE_Vol 02 N 01 by Title
Now showing 1 - 8 of 8
- Results Per Page
- Sort Options
Item Direct torque control of a doubly fed induction generator(جامعة الوادي - university of el oued, 2017-05-25) Ben Amar, A; Belkacem, S; Mahni, TIn this paper a direct torque control system is proposed and is applied to doubly fed induction generator (DFIG) based wind power generation systems. In this control system the rotor flux and the electromagnetic torque are estimated based on the rotor voltage and currents measurements. The validity and effectiveness of this control is demonstrated by some simulation results.Item Fuzzy logic control of wind turbine storage system connected to the grid using multilevel inverter(جامعة الوادي - university of el oued, 2017-03-16) Berboucha, Ali; Djermouni, Kamel; Ghedamsi, Kaci; Aouzellag, , DjamalThis paper aimed to evaluate the use of wind turbine storage systems to provide electricity in the electrical grid through a five-level inverter. The proposed system is composed of four wind turbine generators based on permanent magnet synchronous generator (PMSG), four battery storage systems connected to each capacitor of the DC link and a five level diode clamped inverter connected to the grid by three phase transformer. The control algorithm proposed is based on fuzzy logic to tracks and extract the maximum wind power by controlling the rotational speed of wind turbine, which is most appropriate when there is a lack of information on the characteristic Cp (λ, β) of the turbine. The system operator controls the power production of the four wind turbine generators by sending out reference power signals to each input side regulation unit, the input side regulation units regulate the voltage of each capacitor of the DC link, regulate the voltage and the state of charge of each battery storage system. The inverter is controlled by simplified space vector modulation which allows us to reduce the computational time and reduce the algorithm complexity compared to the conventional five levels space vector modulation, the grid side control level regulate the power and the current injected to the gridItem Insight into rotational effects on a horizontal axis wind turbine NREL phase II using CFD simulation and inverse BEM(جامعة الوادي - university of el oued, 2017-01-31) Belamadi, Riyadh; Mdouki, Ramzi; Adrian, IlincaIlinca; Djemili, AbdelouahebThe present work aims to study the aerodynamic characteristics of the NREL phase II rotor (generated only with S809 profile along the span for an untwisted case) that is a horizontal axis downwind wind turbine rotor and which is assumed to stand isolated in the space. The threedimensional steady-incompressible flow Reynolds Averaged Navier-Stokes equations are solved by using the commercial CFD package ANSYS FLUENT and, the turbulence closure model k-ω with shear stress transport correction was adopted for all computations. The computations were done for wind speed of 7.2, 10.56, 12.85, 16.3, and 9.18 m.s-1. Results of pressure and torque for considered wind turbine rotor have been directly compared to the available experimental data. The comparisons show that CFD results along with the turbulence model can predict the spanwise loading of the wind turbine rotor with reasonable agreement. Secondly, A comparison of lift and drag coefficients was made between the results obtained using the inverse algorithm BEM based on the calculated pressure distributions and the experimental test data. The result show that the general trend is similar for all sections of the scale, however, large deviation exists between the 2-D and 3-D caseItem Investigation of PLC for logic Selectivity Communication in Protection Systems(جامعة الوادي - university of el oued, 2016-03-06) Boughazala, Mohamed; Cheriet, A; Ben Attous, DThis paper reports an investigation of power line communication technique PLC for logic selectivity in protection systems. A simulation of power grid with two protection systems using PLC as communication process is performed by Simulink/Matlab program. Also, the attenuation characteristic of high frequency PLC signal is studied regards to resistance, inductance and frequency variationItem Optimal DG location and sizing for minimum active power loss in radial distribution system using firefly algorithm(جامعة الوادي - university of el oued, 2017-05-25) Remha, S; Chettih, S; Arif, SIn this paper, a novel optimization algorithm is presented for the optimal location and sizing of Distributed Generation (DG) units on distribution systems. For this purpose, a recently based meta-heuristic called Firefly Algorithm (FA) has been employed to minimize the total active power losses. The results show considerably improved in voltage profiles of all the buses and enhance the voltage stability index. The investigations were tested on IEEE 33 bus radial distribution system. Simulation results demonstrate the effectiveness of firefly algorithm. Comparison with another method is also given.Item Piezometric variation of the water table in the the Municipality of El- Oued, south-east Algeria(جامعة الوادي - university of el oued, 2017-06-27) Brahim, Zine; Zaiz, IssamMunicipality of El-Oued has been confronted with the phenomenon of the upwelling of water for several years and without almost any cease to become more extensive each year. This phenomenon took very alarming dimensions the last twenty years. The use of the deep layers water (the Continental intercalary and the Final Complex) in an excessive way considerably increased the volume of the water input, as well as the absence of a natural discharge system for the rejections of wastewater, are the principal causes of this ecological imbalance. Contributing to the deterioration of the palm trees, the inundation of (Ghouts) causes mortal consequences at the level of environment, agriculture, the economy and the health of Municipality of El-Oued. The piezometric variation of the water table has shown that in the areas of upwelling groundwater; correspond to piezometric depressions which has favored the accumulation and especially of the waste water.Item Seasonal effect on solar distillation in the El-Oued region of south-east Algeria(Seasonal effect on solar distillation in the El-Oued region of south-east Algeria, 2017-07-27) Khechekhouche, A; Boukhari, A; Driss, Z; Benhissen, NIn the present purely experimental work, we tested a solar distiller with a simple slope in the region of El-Oued located in the south-east of Algeria, during the winter then the summer seasons at the same place. Dimensions of the studied device are 1000 x 500 mm, while the depth of the water to be distilled is 1 cm, the glazing thickness is 4 mm, and the tilt angle with respect to the horizontal is 10 °.The aim of this work is to compare distillation between winter (January) and summer (May) to show that weather factors such as solar radiation, ambient temperature and humidity are influential on the distiller productivity. The amount of distilled water in winter was about 119 ml per day. However, that in summer was 1127 ml per day in total, so it is an increase of more than 9 times the production of distilled water.Item Study of the aerodynamic structure around a NACA6409 Aairfoil rotor(جامعة الوادي - university of el oued, 2017-04-11) Gouiaa, Saoussane; Ameni, Ameni; Driss, Zied; Ben Amira, BilelThe multi-copters are one of the important aircrafts in the world because they are used in both military and civil application. The problem of these aircrafts is the low efficiency of its propellers. That’s why, it is necessary to study the aerodynamic structure around every rotor. In this paper, a computer simulation has been done to study the aerodynamic structure around a NACA 6409 airfoil rotor. The numerical model is based on the resolution of the Navier - Stockes equations with a standard k-ε model. Then, the finite volume discretization of these equations leads to solve it. The local characteristics of the aerodynamic structure are extracted using the software Solidworks Flow Simulation and the validation is done with comparison with anterior result of Alexandrov [1].