Browsing by Author "Ben Attous, D"

Filter results by typing the first few letters
Now showing 1 - 4 of 4
  • No Thumbnail Available
    Item
    Investigation of PLC for logic Selectivity Communication in Protection Systems
    (جامعة الوادي - university of el oued, 2016-03-06) Boughazala, Mohamed; Cheriet, A; Ben Attous, D
    This paper reports an investigation of power line communication technique PLC for logic selectivity in protection systems. A simulation of power grid with two protection systems using PLC as communication process is performed by Simulink/Matlab program. Also, the attenuation characteristic of high frequency PLC signal is studied regards to resistance, inductance and frequency variation
  • No Thumbnail Available
    Item
    SIMULATION FOR STRATEGY OF MAXIMAL WIND ENERGY CAPTURE OF DOUBLY FED INDUCTION GENERATORS
    (جامعة الوادي - university of el oued, 2012) Tria, F; Ben Attous, D
    In the control of the wind generation, the maximal power point tracking (MPPT) control plays important role in the efficiency. This paper presents the simulation results of the MPPT control based DFIG model. At first, it analyzes the vector-control scheme for the MTTP, which results in independent control of active and reactive power of the generator. And then, it develops the MPPT controller implemented on the rectifier and inverter based on PI control
  • No Thumbnail Available
    Item
    Sliding Mode Controls of Active and Reactive Power of a DFIG with MPPT for Variable Speed Wind Energy Conversion
    (Australian Journal of Basic and Applied Sciences, 2011-12) Bekakra, Youcef; Ben Attous, D
    This paper presents the study of a variable speed wind energy conversion system based on a Doubly Fed Induction Generator (DFIG) based on a sliding mode control applied to achieve control of active and reactive powers exchanged between the stator of the DFIG and the grid to ensure a Maximum Power Point Tracking (MPPT) of a wind energy conversion system. The proposed control algorithm is applied to a DFIG whose stator is directly connected to the grid and the rotor is connected to the PWM converter. To extract a maximum of power, the rotor side converter is controlled by using a stator flux-oriented strategy. The created decoupling control between active and reactive stator power allows keeping the power factor close to unity. Simulation results show that the wind turbine can operate at its optimum energy for a wide range of wind speed.
  • No Thumbnail Available
    Item
    Speed Control of a Doubly Fed Induction Motor using Fuzzy Logic Techniques
    (School of Electrical Engineering and Informatics, Bandung Institute of Techonolgy, Indonesia, 2010-07-01) Ben Attous, D; Bekakra, Youcef
    This paper presents a comparison between a fuzzy logic controller and a conventional IP controller used for speed control with a direct stator flux orientation control of a doubly fed induction motor. The effectiveness of the proposed control strategy is evaluated under different operating conditions such as of reference speed and for load torque step changes at nominal parameters and in the presence of parameter variation. Simulation results show that the fuzzy logic controller is more robust than a conventional IP controller against parameter variation and uncertainty, and is less sensitive to external load torque disturbance with a fast dynamic response.